Tom Scribner
- Total activity 24
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 5
- Subscriptions 9
Posts
Recent activity by Tom Scribner-
PLT Unable to Boot with Scanner
Hi, We are using a Zebra LS2208 Hand Scanner and the PLT200 is unable to complete booting with the scanner plugged into the USB port. If I unplug the scanner and power down/up the PLT200 is it ab...
-
No Label Print upon Failure
Is there a way to NOT print a label upon a test failure?
-
Can't dial error message with BLE gatt connect
When I try to make a connection via ble, I receive the error message "can't dial: connection canceled" 57.062s PROD-02.2 ble gatt connect name:%BCASTNAME% 30 FAIL connect: can't dial: can't di...
-
Problem with 1st time program command
I'm noticing a situation where after a reset, my program statement fails. If after the failure I press the start again, the program statement will succeed. My script is below. NOTE: The 1st progr...
-
Zebra Label Printer Setup
Are there instructions on how to install a Zebra Label Printer. I have a GX430t printer and have connected the printer up to the USB port, however, my label command does not print. I have created...
-
Program DUT without Erase
CompletedDuring your program statement, an automatic erase occur's for the DUT's ram contents. There are situations where the contents of NVRAM should not be erased. It would be nice to have a flag for th...
-
Expecting UART communications
I am working on this script with interaction with my firmware and apparently, it's not working as I expect it to. Basically, I have a bare-bones firmware module that I initiate manufacturing tests...
-
Remote Execution
Have the ability to remotely start a test script